# Cable Installation

### Cable Installation

After you secure the T bracket to the terminal, you must insert the cables. This procedure explains how to install and secure the AC adapter and Ethernet cables; if you have additional cables, connect them to the appropriate port and use the same method to secure them in place.

#### To install and secure the cables:

1. Beginning with the AC adapter, inserting it in the terminal's cable guide on the left and connect the adapter to the **Power** port.

\
![AC adapter installed](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/ACadapterInstalled.jpg)

2. Insert the Ethernet cable in the terminal's cable guide on the right and connect it to the **LAN** port.

\
![Ethernet installed](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/EthernetInstalled.jpg)

3. When the cables are properly seated in their ports, gently pull on the cables to remove any excess cable that is higher than the plane of the T bracket.

\
![Ok cable position](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/CablesOk.png) ![Bad cable position](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/CablesBad.png)

4. Place the 3-hole metal bracket over the cables, aligned with the screw holes in the T bracket and secure it in place using a Phillips head screwdriver to insert the two short screws.

\
![Secure cables](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/SecureCables.jpg)

5. Turn the terminal over and power on the terminal. The completed assembly should resemble the following:

\
![Completed assembly](https://documentation.payfacto.com/Accessories/A80_Cable_Attachment/CA-EN/assets/images/CablesInstalled.png)